This is the NASCAR Heat 5 Cup setup for Dover from The Setup Man's onboard video. Every value below is read from the garage screen, so you can copy it line by line.
On the practice screen it did a 22.778, against a goal of 23.115. That is the high 22s. You get there by getting back on the throttle the moment the car has rotated, not by a magic number in the sheet.
The setup at a glance
| Setting | Value |
|---|---|
| Left front camber | +3.5 deg |
| Right front camber | -2.5 deg |
| Front swaybar | 1.435 in |
| Wheel lock | 10 deg |
| Wedge | 51.8% |
| Rear end ratio | 3.55 |
| Grille tape | 45% |
| Brake bias | 70% |
Here is the garage screen with the full setup:

Full setup sheet
Tyres
| Tyre | Pressure |
|---|---|
| Left front | 19.75 psi |
| Right front | 48.00 psi |
| Left rear | 19.75 psi |
| Right rear | 47.75 psi |
Springs
| Spring | Rate |
|---|---|
| Front left | 1,200 lbs/in |
| Front right | 1,200 lbs/in |
| Rear left | 500 lbs/in |
| Rear right | 580 lbs/in |
Shocks
| Shock | Bump | Rebound |
|---|---|---|
| Front left | 6 clicks | 3 clicks |
| Front right | 3 clicks | 3 clicks |
| Rear left | 3 clicks | 4 clicks |
| Rear right | 4 clicks | 5 clicks |
Weight and ride height
| Setting | Value |
|---|---|
| Left weight | 54.2% |
| Front weight | 51.5% |
| Wedge | 51.8% |
| Front ride height | 4.000 in |
| Rear ride height | 4.000 in |
Misc
| Setting | Value |
|---|---|
| Left front camber | +3.5 deg |
| Right front camber | -2.5 deg |
| Front swaybar | 1.435 in |
| Left track bar | 11.25 in |
| Right track bar | 11.75 in |
| Brake bias | 70% |
| Grille tape | 45% |
| Wheel lock | 10 deg |
| Steering offset | 0.125 |
Gears
| Gear | Ratio |
|---|---|
| 1st | 2.70 |
| 2nd | 1.80 |
| 3rd | 1.35 |
| Rear end ratio | 3.55 |
The rear swaybar and 4th gear are greyed out on the screen, so there is nothing to set there.
The lap it does

This is the practice result with the setup: a 22.778, first in the session, a third of a second under the goal. Here is the onboard from The Setup Man:
Why the setup looks like this
Dover is an oval, so you only turn left and the load goes onto the right side tyres. That is why the right side runs more than double the pressure of the left, and why both front tyres lean left: +3.5 on the inside tyre, -2.5 on the loaded outside one.
Next to my Kansas Cup setup, Dover runs a higher rear end ratio (3.55 against 3.10) and less grille tape (45% against 55%). The ratio makes sense: Dover is a one mile track against Kansas at a mile and a half, so the straights are short and you want the car to pull hard off the corner.
The wedge is 51.8%, half a point more than Kansas. More wedge keeps the rear planted on exit, which matters on a track where you are back on the throttle while the car is still loaded in the banking.
The track

Dover Motor Speedway is a one mile oval in Dover, Delaware, opened in 1969. The numbers that matter for the setup, from the track's Wikipedia page:
| Part of the track | Value |
|---|---|
| Length | 1.000 mile |
| Banking in the turns | 24 degrees |
| Banking on the straights | 9 degrees |
| Surface | Concrete since 1995, asphalt before |
24 degrees is a lot of banking for a one mile track. The car is pressed into the surface through the whole turn, then the straight comes at you fast.
How I drive it
- Get back on the throttle the moment the car has rotated. Every tenth you wait costs you the whole next straight.
- Do not let the rear move on exit. Too much oversteer here costs you confidence first and then lap time.
- Find a faster car to follow. The draft helps your top speed even on a one mile track.
- Be patient on entry. Let the banking hold the car before you ask it to turn more.
How to tune it for your driving
Change one thing at a time and run five laps before you judge it. The directions below are standard stock car logic, so check each one on track.
| Problem | First change |
|---|---|
| Rear steps out on corner exit | Raise the wedge a little |
| Car will not turn in the middle of the corner | Lower the wedge a little |
| Engine hits the limiter before the corner | Lower the rear end ratio |
| Car feels slow off the corner | Raise the rear end ratio |
| Front end washes out late in a run | Take 1 psi out of the right front |
With the servers closed since 1 August 2025, this setup is for career mode, quick races and split-screen. Set the AI first with my NASCAR Heat 5 AI settings, then judge the setup against them.
More NASCAR Heat 5 setups
- All 20 tracks are in my NASCAR Heat 5 Cup setups database.
- Same track, other car: Dover Xfinity setup.
- Other short tracks: Bristol Cup setup and Martinsville Cup setup.
- Wheel not right yet? Start with my NASCAR Heat 5 FFB settings.
FAQ
What is the best camber for Dover in NASCAR Heat 5?
This setup runs +3.5 degrees on the left front and -2.5 degrees on the right front in the Cup car.
What lap time can this setup do at Dover?
On the practice screen it did a 22.778, against a goal of 23.115.
What wedge should I run at Dover?
51.8% in this setup. If the rear steps out on exit, go up a little. If the car pushes in the middle of the corner, go down a little.
What rear end ratio works at Dover?
3.55, with gears of 2.70, 1.80 and 1.35 for 1st to 3rd.
How much banking does Dover have?
24 degrees in the turns and 9 on the straights, on a one mile concrete oval.

