Are you one of the many players who are trying to locate the most effective Nascar Heat 5 setups but to no avail?
At NH5 racing in Dover, it’s clear that possessing a good NASCAR Xfinity setup is quite important especially with the rough Daytona circuit.
If you want to achieve mid 45s then getting a good car setup is essential for maximum chances.
For the front right wheel you should consider a camber of negative 2.5 degrees and for the left wheel a camber of positive 2.5 degrees will be sufficient.
The positive camber on the left wheel will assist in the initial turn while the negative camber on the right will aid in mid-corner rotation phase. This is the most phase of highest tire load.
Try to have a swaybar of about 1.500° which ensures a good rotating angle of the car thereby not too much disturbance to the rear area.
Also, none too little oversteer is crucial as it would be a further detriment to your confidence in the later stages.
For gearing, a rear-end ratio of 3.10 coupled with a 3 gear setup is recommended.
Nascar Heat 5 Daytona Xfinity – video onboard
Here is a short video with Xfinity car during race around Daytona created by “The Setup Man” who will give you tips on driving and ideally reduce your lap time as well.
Do you want a reliable setup that has recorded times in the mid 45s? To achieve this, simply watch the video and figure out his setup.
NASCAR Heat 5 Xfinity Setups
- Atlanta
- Auto Club Speedway
- Bristol
- Charlotte Roval
- Chicagoland
- Darlington
- Dover
- Homestead
- Iowa
- Indy
- Las Vegas
- Michigan
- Mid Ohio
- Martinsville
- New Hampshire
- Kansas
- Kentucky
- Phoenix
- Road America
