Nascar Heat 5 Iowa Xfinity Setup

Nascar Heat 5 Iowa Xfinity Setup

Have you been looking around for the latest and best setups in Nascar Heat 5 but struggled to find any good ones?

We all know how essential it is to have a great NASCAR Xfinity setup in NH5, especially in such a tricky circuit as Iowa Speedway.

If you’re looking to crack into the low 23s then you’ll want to make sure you get yourself a great car setup to give you the best chance to succeed.

Nascar Heat 5 Iowa Xfinity Setup

You’ll want to run a negative 3.0° camber on the front right and a positive 4.0° camber on the front left.

That’s because you’ll need the positive left camber for the turn-in phase while the negative front right camber will help support the load of the car in the rolling phase of the corner.

You’ll want a pretty soft front swaybar around 1.435° since it will help you turn the car nicely on entry, while at the same time not losing the rear end too much at the apex.

It’s really key to not have too much oversteer in ovals like these as it will only cause you to lose confidence and lap time.

In terms of gearing, you’ll want to run a 3 gears setup with a rear-end ratio of 4.22 as the track is pretty short and the average speed is quite low.

Nascar Heat 5 Mid Ohio Xfinity – video onboard

Here’s a brief video onboard around Iowa with the Xfinity car from “The Setup Man” which will help you improve your driving and ideally your lap times.

Make sure you get yourself a bit of draft as that could improve your laptimes by 2 or 3 tenths.

NASCAR Heat 5 Xfinity Setups

error: Content is protected !!